My smart car broke down on me i discovered that the 40 amp fuse had blown and got the dreaded 3 lines on my dashboard i changed the fuse and then had only 1 line on the dash i looked underneath the car and discovered the actuator cable had rubbed against the chassis and this is what proberly blew the fuse i then removed the actuator and discovered the actuator motor was not working proberly burnt out i replaced the actuator and motor with a working one and discovered the car would start but no drive and the actuator motor
Is trying to continuely push the actuator rod out and disengage the clutch hence no drive i disconnected the plug to the actuator as the motor was getting hot and would obviously burn out it seems to me there is no signal to tell the motor to retract the actuator and then stop till next single if that makes sense anyone got any ideas please
Paul